|
|
|
|
|
The disable statement provides means of terminating active procedures.
disable task_identifier;
disable block_identifier;
The disable statement can be used to terminate tasks (Example 1), named blocks (Example 2) and loop statements (Example 3) or for skipping statements in loop iteration statements (Example 4). Using the disable keyword followed by a task or block identifier will only disable tasks and named blocks. It cannot disable functions. If the task that is being disabled enables other tasks, all enabled tasks will be terminated.
If a task is enabled more than once, then disabling that task terminates all its instances.
Example 1
task t;
output o;
integer o;
#100 o = 15;
endtask
disable t; // Disabling task t.
Example 2
begin : named_block
a = 1; // #1
disable named_block;
a = 2; // #2
end
Statement #2 will never be executed, therefore after execution of this block, variable 'a' will have 1 as its value.
Example 3
begin : break_block
i = 0;
forever begin
if (i==a)
disable break_block;
#1 i = i + 1;
end
end
The forever statement will be executed until 'i' is not equal to 'a'.
Example 4
begin
i = 0;
forever begin
: continue_block
if (i==a)
disable continue_block;
#1 i = i + 1;
end
end
If 'i' is equal to 'a' then statement (#1 i = i + 1) that appears after the disable statement will not be executed.
The disable statement cannot be used to disable functions.
If a task or a named block contains other tasks or named blocks then disabling that task or a named block terminates all tasks and blocks within.
The disable statement can appear only within the procedural blocks.
|
|
|
|
|
| Powered by IXwebhosting |